Best drill press

If you need to join steel or copper tubes together, you can do it by soldering, welding or brazing, and sometimes it’s preferred or even required to do it mechanically. To create a mechanical connection on tubes flaring is used. Flaring is used to make gas-tight or liquid-tight joint, and this process means forming the end of a tube.

Double-lap flaring offers additional strength for tube ends, that are subjected to more fatigue and stress. The joint is designed so that the inside surface of the flare has a larger diameter so it does not interfere with flow characteristics of the system. To meet the same specifications as the Single Flare, Double-lap flaring can be formed in the same shapes - best drill press.

Single flaring is the most used and the simplest process of flaring The single flare is available in both 37 and 45 degrees. There are two ways to accomplish a flared tube end – rotary or spinning, and a ram forming the flared end.

To make sure that the jointof tubes using fitting will be leak-tight, you have to flare tubing properly using the proper tools and techniques. The first thing is cutting the right length of tubing with a proper tool. Secondly, don’t forget to slide the compression nut on a tubing The last step is to use a flaring tool kit to make a flaring itself.

Most of flaring kits are relatively inexpensive and easy to find, despite the fact that different sizes of tubes require specific sets of equipment. To cut a tube the special cutting tool is used. A flaring tool kit usually consists of two main pieces – a reamer and a flare form. A flare form is like a clamp with a number of holes used for various tube diameters. The tubing is firmly held by the flare form, allowing you to flare the pipe using minimum strength The thing that makes the actual flaring is reamer, which has holding arms, a screw, and a conical point.